Assembly of the galvanized loading lifting table
loading lift tables are generally used to load and unload semi-trailers, trucks or flatbed trucks. Submerged in a pit, you can use a classic hand pallet truck to place pallets, pallet boxes or your goods. The vehicle drives in front of the stage, you set the desired loading height, fold the loading flaps into the vehicle and you can easily load the goods.
Fall protection on the loading lifting table
On the Lift table platform became galvanized railings installed. These are necessary so that the operator or the goods cannot fall off the platform when loading. The front side - towards the vehicle - can remain open as there is no risk of falling here.
In the lower lifting position, the railings can simply be lifted out so that you can unload them on the building side using a pallet truck or forklift. Whether the railings are electrically controlled or not depends on the official requirements. If a query is necessary, the loading lifting table only lifts if the railings are stuck in the platform.
Pictures of the assembly of the loading lifting table
Raise the lifting table with a crane
The delivery of our loading lift tablesThe ones we assemble are usually done with crane trucks.
We hook the chains from the crane into the included lifting eyes and lift it lifting table directly from the truck into the concrete pit created by the customer. The lifting eyes are screwed through the platform into the base frame.
The packaging and the pallet must be dismantled hanging on the crane, as you can no longer access it in the pit.
The first hub without power
Loading lifting table with loading flaps
Aggregate and control external
At Loading lifting tables in the outdoor area We always recommend positioning the drive and control outside the pit. If there is a flood due to heavy rain, the pit always fills up with water first. Placing it externally ensures that these components do not suffer water damage.
In this project, the customer chose a special location for the drive. We had to mount the unit at a height of 2m.
For this purpose, we have manufactured a collecting tray so that it can be screwed to the wall on site.
The customer didn't want a cable duct, so we laid the hydraulic hose and cables surface-mounted. To ensure that it still looks neat, attention was paid to the required length in advance.
Regardless of whether we carry out the assembly of a loading lifting table or the customer, it is always important to us to provide proper construction information. Good preparation will save you a lot of time later.