Mounting from the galvanized loading lift table
Loading lifting tables are usually used to load and unload semi-trailers, trucks or flatbed trucks. Sunk in a pit, you can store pallets, lattice boxes or your goods with a classic hand pallet truck. The vehicle drives in front of the stage, you set the desired loading height, fold the loading flaps into the vehicle and can easily load the goods.
Fall protection at the loading lifting table
Galvanized plug-in railings were installed on the lifting table platform. These are necessary so that the operator or the goods cannot fall off the platform when loading. The front side – towards the vehicle – can remain open, as there is no risk of falling here.
In the lower lifting position, the railings can simply be lifted out so that you can unload on the building side with the pallet truck or forklift. Whether the railings are electrically queried or not depends on the official requirements. If a query is necessary, the loading lifting table only lifts when the railings are stuck in the platform.
Pictures of the assembly of the loading lifting table
Lifting table with crane
The delivery of our loading lifting tables,which we assemble, is usually done by crane truck.
We hang the chains from the crane into the included lifting eyelets and lift the lifting table directly from the truck into the concrete pit created by the customer. The lifting eyelets are screwed through the platform into the base frame.
The packaging and the pallet must be removed hanging from the crane, as you can no longer get to it in the pit.
The first hub without power
Loading lift table with loading flaps
External unit and control
For outdoor loading lifting tables, we always recommend positioning the drive and control outside the pit. If there is a flood due to heavy rain, the pit always fills with water first. The external installation ensures that these components do not suffer water damage.
In this project, the customer has chosen a special place for the drive. We had to install the unit at a height of 2m.
For this purpose, we have manufactured a drip tray in such a way that it can be screwed to the wall on site.
The customer did not want a cable duct, so we laid the hydraulic hose and the cables surface-mounted. To ensure that this still looks neat, attention has already been paid to the required length in advance.
No matter whether we carry out the assembly from a loading lifting table or the customer, it is always important to us to provide proper construction information. Good preparation saves you a lot of time later.
Order lifting tables now
If you have any questions, please contact us immediately. We are looking forward to it!